NNOTE: If the program displays an error when attempting to select the default folders, ensure you have these folders on your C:\ drive (if not, create it as an empty folder): We will move to the next step of configuring your KDCAN cable drivers. This is due to the copying of large files that’s utilized to flash your CIC.Īt this point, you’re software is completely set up for coding and/or flashing. Depending on your chassis, this will appear to freeze at times while copying CI*** files/folders.
You will only need to use button 6 if you’re planning on flashing updated software to any of your modules.īutton 6, Click this button to import the files required to update the software on your modules. At this point, you’re able to begin coding and utilizing INPA for troubleshooting. If not, this import process will not work.īutton 2, Select the NCS Expert folder that you copied to your C: drive in step 15.īutton 3, Select the Ediabas folder that you copied to your C: drive in step 15.īutton 4, Select the EC-APPS\NFS folder that you copied to your C: drive in step 15.īutton 5, Click this button to begin the process of importing your DATEN. The DATEN folder must not be a zipped file and must contain the following folders (cfgdat, data, daten, ecu, format, kmmData, sgdat, work).
This install was primarily used to create all the environment variables and registry entries necessary to run these programs. No need to do this, can use software without rebooting.ġ4.Select the 3 folders below and delete them. We can change this later if need be.ġ3.Select “No, I will restart the computer later” and click “Finish”. Select the default location for each of the programs being installed on next few screens.ħ.Select the default Start Menu Folder by clicking “Next”.Ĩ.Uncheck both “Execute backup and restore wizard and click next.ġ0.Select the default interface by clicking “Next”.ġ1.Select default Com Port (Com 1) by clicking next.